Hyundai Tucson: Rear Bumper / Rear Bumper beam Assembly
1. Rear bumper beam assembly
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Put on gloves to prevent hand injuries.
• Take care not to bend or scratch the bumper cover and panels.
1.Remove the rear bumper assembly.(Refer to Rear Bumper - "Rear Bumper Assembly")
2.Disconnect the antenna connector (A) and loosen the mounting clips, remove the rear bumper beam assembly (B).
3.To install, reverse removal procedure.
• Make sure the connector is plugged in properly.
• Replace any damaged clips (or pin-type retainers).
Rear Bumper Assembly
- Component Location
1. Rear bumper assembly
- Replacement
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent ...
Front Seat
...
Other information:
Hyundai Tucson (NX4) 2022-2025 Service Manual: General Information
- Important Safety Notice
Proper service methods and repair procedures are essential for safe,
reliable operation of all motor vehicles as well as personal safety of
the operator. The service procedures and descriptions in this shop
manual provide general directions for a service and repair ...
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: High Beam Assist Malfunction
and Limitations
System malfunction
When High Beam Assist is not working
properly, the "Check High Beam Assist
(HBA) system" warning message may
appear, and the warning light may
illuminate on the instrument cluster.
Contact an authorized HYUNDAI dealer.
Limitations of High Beam Assist
High Beam Assi ...
