1.Place the lift blocks under the support points as shown in the illustration.
2.Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.
3.Raise the hoist to full height to inspect the lift points for secure support.


• Do not jack up about 180mm (7.1 in.) from the edge of S/SILL MLD's.
• Place the support within 45mm (1.7in.) from the back or forth of jack up notch.
1.Position the lift aligned with the side seal of the vehicle bottom.
2.Raise the hoist to full height to check whether the vehicle is firmly supported.

1.Place the vehicle on the lower side of the lift body.
• When raising the vehicle with a scissor car lift to service the bottom of the vehicle, check the vehicle bottom and make sure not to damage the floor under cover, fuel tank, fuel filter and canister. Also, use a rubber support or stanchion on the side seal of the vehicle body.
2.Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.
3.Raise the hoist to full height to inspect the lift points for secure support.

TowingHyundai Tucson (NX4) 2022-2025 Service Manual: USB Jack
- Description
The USB jack on the console upper cover is for customers who like to
listen to external portable music players like the USB, MP3 through the
vehicle's sound system when it is linked to this jack. The customer has
this added option.
- Connector Pin Information
- Re ...
Hyundai Tucson (NX4) 2022-2025 Owner's Manual: Smart Cruise Control display
The status of the Smart Cruise Control
operation appears in Driving Assist mode
on the instrument cluster. Refer to the
"View Modes" section in Chapter 4.
When operating
1 Whether there is a vehicle ahead and
the selected distance level appears.
2 Set speed appears.
3 Whether there i ...