When the wipers no longer clean adequately, the blades may be worn or cracked. Replace the wipers with new ones.
NOTICE
To prevent damage:
Front windshield wiper blade replacement
This vehicle has a “hidden” wiper design that cannot be lifted when in their bottom resting position.
1. Within 20 seconds of turning off the engine, lift and hold the wiper lever up to the MIST position for about 2 seconds until the wipers move to the top wipe position.
2. Lift the wipers off the windshield.
Type A
3. Rotate the wiper blade to access the clip.
4. While pushing the clip 1, pull down the wiper blade 2.
5. Remove the wiper blade from the wiper arm.
6. Install a new wiper blade assembly in the reverse order of removal.
7. Gently put down the wiper back onto the windshield.
8. Turn the wipers to any ON position to return the wiper arms to the bottom resting position.
Type B
3. Lift up the wiper blade clip 1. Then pull down the wiper blade 2.
4. Remove the wiper blade from the wiper arm.
5. Install a new wiper blade assembly in the reverse order of removal.
6. Gently put down the wiper back onto the windshield.
7. Turn the wipers to any ON position to return the wiper arms to the bottom resting position.
Rear window wiper blade replacement
1. Within 20 seconds after the vehicle ignition is OFF, pull down the wiper lever to MIST position for over 2 seconds until the wiper moves down to the bottom middle part.
2. Raise the wiper arm.
3. Lift up the wiper blade, and pull it out.
4. Install the new blade assembly by inserting the center part into the slot in the wiper arm until it clicks into place.
If the replacement is complete, put down the wiper arm onto the rear windshield, and turn the vehicle ignition to ON and operate the wipers to check the blade is installed correctly.
NOTICE
The rear wiper may not operate for about 10 seconds if the wiper is operated without washer fluid or the blades are frozen to prevent damage to the motor.
Hyundai Tucson (NX4) 2022-2023 Owner's Manual: Blind-Spot Collision Warning (BCW)
Blind-Spot Collision Warning uses
the rear corner radar to help detect
approaching vehicles in the driver’s blind
spot areas and warn you of a possible
collision with a warning message and
audible warning.
Blind-Spot Collision Warning helps
detect and warns you that a vehicle is in ...
Hyundai Tucson (NX4) 2022-2023 Owner's Manual: Highway Driving Assist
Operation
Highway Driving Assist display
The status of the Highway Driving Assist
operation appears in Driving Assist mode
on the instrument cluster. Refer to the
"View Modes" section in Chapter 4.
1 Indicates if there is a vehicle ahead
and the selected distance level
appears.
Highway Driving ...